[Clas12_calcom] [EXTERNAL] RGA Fa18 Inb+Out QA timelines available

[Raffaella De Vita]

Dear Timothy,

FTCal is within specs too, with two exceptions;
- runs 4795-4798, where the pi0 mass is slightly above the upper limit;
- runs 5126-5127, where the pi0 mass is slightly below the limit.
I’m not sure there is much that can be done for the first, or whether it would be worth doing something because the statistics for energy calibrations of those early runs is very limited. I can fix the second, assigning to them the constants of the following run range.

All the other outliers are empty target runs for which the calibrations are fine but the information shown by the timelines is unreliable.

Best regards,
Raffaella

On 22 Aug 2023, at 00:32, Hayward, Timothy <timothy.hayward at uconn.edu<mailto:timothy.hayward at uconn.edu>> wrote:

Dear CALCOM,

The RGA Fa18 inbending and outbending QA timelines are available<https://clas12mon.jlab.org/timelines/?rg=rga3> on clas12mon. Note that there are separate timelines for inbending: rga_fa18_v0.23_in_qa<https://clas12mon.jlab.org/rga/pass2/fa18/pass0/rga_fa18_v0.23_in_qa/tlsummary/> and outbending: rga_fa18_v0.23_out_qa<https://clas12mon.jlab.org/rga/pass2/fa18/pass0/rga_fa18_v0.23_out_qa/tlsummary/>. Please let me know your thoughts about your subsystems as absolutely soon as possible.

Best regards,
Timothy

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/clas12_calcom/attachments/20230822/b67477ff/attachment.html>