[Clas12_rich] Fwd: Re: RICH Pressure Relief Valves

[Tomassini Sandro]

Hi George 
For me it's OK.
Please check if the height is OK and does not interfere with the hall b crane as recommended by Bob.
Ciao
Sandro

Dr Eng. S. Tomassini

Il 24/mag/2016 21:04 George Jacobs <jacobsg at jlab.org> ha scritto:
>
> In order to simplify procurement I would recommend the following ASME air tank in place of the one listed;
>
> McMaster Carr part # 9554K71
> http://www.mcmaster.com/#9554k71/=12jwvqh
>
> I have attached pdf of tank.
>
> George
>
> On 5/24/2016 2:48 PM, Saptarshi Mandal wrote:
>>
>>
>>
>>
>> -------- Forwarded Message --------
>> Subject:
>> Re: RICH Pressure Relief Valves
>> Date:
>> Tue, 24 May 2016 08:04:08 +0200
>> From:
>> Tomassini Sandro <sandro.tomassini at lnf.infn.it>
>> To:
>> Saptarshi Mandal <mandal at jlab.org>
>> CC:
>> Mirazita Marco <marco.mirazita at lnf.infn.it>, vincenzo.lucherini at lnf.infn.it, dario.orecchini at gmail.com
>>
>>
>> Hi Saptarshi,
>>
>> attached this mail you can find the tank datasheet. The allowable working pressure of the tank  is 11.5 bar.
>>
>> Please refer to the compressor datasheet attached to this e-mail, as you can see the pressure are expressed as absolute values
>>
>> Pressione operativa
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/clas12_rich/attachments/20160524/47a36259/attachment.html>