[d2n-analysis-talk] Xin Geant 3 sim

[posik at jlab.org]

Hi all,

  Here is the email that Xin had sent me regarding his Geant 3 simulations:



Hi Matthew,
   Please find the information below. Those are the two emails I sent to
two different people explaining about the program. Please go through
them and let me know if there is any problems.

Best regards,

Xin

> Hi Jin,
>         Here are some very limited information. Just go through them to see
> if you have any questions. I am happy to answer them.
>         1. old source code for comgeant:
>                /w/halla/e03004/xin/HALLA
>        You may find the latest one from Eugene, I do not have them.
>        2. manual www.jlab.org/~gen
>
>         3. code /w/halla/e03004/xin/12gev/TRANSVERSITY/BigBite
>         4. There is a readme there.
>         5. To run the code: see
>                 /w/halla/e03004/xin/12gev/TRANSVERSITY/BigBite/run_sim
>
>         6. choose the workspace 1
>        7. You can run "exec plot_setup.kumac" to see the geometry
>        8. Just read through the hitraxy.f or getkinp.f etc after running
the
> simuation, like "trig 10000". Then
>        9. you can open the nt like "hi/file 1 csimout.nt"
>         10. you can then do "nt/plot //LUN1/2.hitraxy.f(....)"
>
>
>
> Best regards,
>
> Xin
>



        Here are the information that you may need:
         1. old source code for comgeant:
                 /w/halla/e03004/xin/HALLA
         You may find the latest one from Eugene, I do not have them.
         2. manual www.jlab.org/~gen
         3. geometry code
         /w/halla/e03004/xin/12gev/TRANSVERSITY/sol_transv_largeangle_new
         4. excutable file: (this is a copy from Eugene, hopefully, you
can run
it)
         /w/halla/e03004/xin/12gev/TRANSVERSITY/comg_inter.rhws3u.exe
         5. The code that I used to decode the information from Eugene's
file is
@ /w/halla/e03004/xin/12gev/TRANSVERSITY/1stnt/extract_info

         Now, I just give you a little bit hint of how to run it :P

         1. to run the simulation, you neeed to copy the
"comg_inter.rhws3u.exe"
to the running directory, and run "./comg_inter.rhws3u.exe"
         2. choose the workspace 1
         3. You can run "exec plot_setup.kumac" to see the geometry
         4. Just read through the hitraxy.f or getkinp.f etc after
running the
simulation, like "trig 10000". Then
         5. you can open the nt like "hi/file 1 csimout.nt"
         6. you can then do "nt/plot //LUN1/2.hitraxy.f(....)">



-Matt