[Dsg-halla] Items discussed for BigBite modules today

[Tyler Lemon]

Hi Bogdan,

Just to keep everyone else in formed, below are additional things we discussed today:

To cut the aluminized mylar, you cut a sheet from the roll and then trim it to size using the cutter (for the others, it looks like a cutting board with a blade attached to the side on a hinge). The cutter that is in the assembly area is dull and does not cut the mylar, so you said you would find another one for us to use.

We were able to partially wrap three modules today. The three were cleaned with water and alcohol, per the procedure, and then wrapped with the large sheet of mylar. We did not have the smaller sheets to finish wrapping the end and we could not cut them because the cutter is too dull.

We'll continue wrapping next week.

-Tyler
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla/attachments/20200221/9f0d9b4b/attachment.html>