[Dsg-halla_cleo] Magnetometer kits

[Brian Eng]

I already installed the software on all the boards. The SD card is only for datalogging, but it is required for the system to completely boot. Any newly assembled kit should fully boot to the screen that Marc attached earlier showing the sensor values.

However, they'll all need to be updated again anyway as I hard-coded the guest wifi password, which should rotate next week.

O:\DSG\Hall A\CLEO Mapping\cleo_mapper.ino has the currently loaded code.

________________________________
From: Dsg-halla_cleo <dsg-halla_cleo-bounces at jlab.org> on behalf of Marc Mcmullen <mcmullen at jlab.org>
Sent: Tuesday, November 29, 2022 10:54 AM
To: Amrit Yegneswaran <yeg at jlab.org>; dsg-halla_cleo at jlab.org <dsg-halla_cleo at jlab.org>
Cc: Patrizia Rossi <rossi at jlab.org>
Subject: Re: [Dsg-halla_cleo] Magnetometer kits

We should have all the mapping units assembled by Monday. We have two completed units with a version of the operational software. I'll reach out to Brian and see if the software on those two have been tested and are good to go. If so, I'll load that software on SD cards for the rest of them.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla_cleo/attachments/20221129/db79b618/attachment.html>