[Dsg-halla_lappd] Pulser type

[Pablo Campero Rojas]

Hello Simona,


The recommended direct replacement for the old Agilent 33522A signal generator is the Keysight 33522B, however, by looking at the specs I noticed that this one has the same minimum pulse width of 16 ns.

Since the minimum pulse width for the generated signal is critical for the LAPPD test setup, an upgrade would be the Keysight 33622A which has a minimum pulse width of 5 ns (1-ps resolution).

33622A Waveform Generator, 120 MHz, 2 Channel | Keysight<https://www.keysight.com/us/en/product/33622A/waveform-generator-120-mhz-2-channel.html>


-Pablo
________________________________
From: Simona Malace <simona at jlab.org>
Sent: Friday, February 23, 2024 10:52 AM
To: Pablo Campero Rojas <campero at jlab.org>
Subject: Re: Pulser type

what would you suggest for an upgrade?

We were talking about it...my only requirements are that I can control the freq., make pos and neg polarity pulses, minimum pulse widths 10-20 ns or less, few generator function types.

Thanks.

Simona
________________________________
From: Pablo Campero Rojas <campero at jlab.org>
Sent: Friday, February 23, 2024 10:49 AM
To: Simona Malace <simona at jlab.org>
Subject: Re: Pulser type

Hello Simona,

This version does not have the GPIB connector as you noticed the GPIB slot is empty.

I'll find out if we can still use the USB or Ethernet ports for connection.

I found that this particular model has been discontinued and it's obsolete.
Any news on upgrading this signal generator?


-Pablo
________________________________
From: Simona Malace <simona at jlab.org>
Sent: Thursday, February 22, 2024 1:53 PM
To: Pablo Campero Rojas <campero at jlab.org>
Subject: Re: Pulser type

Hi Pablo

Here it is.

Thanks

Simona

Get Outlook for Android<https://aka.ms/AAb9ysg>
________________________________
From: Pablo Campero Rojas <campero at jlab.org>
Sent: Thursday, February 22, 2024 12:54:01 PM
To: Simona Malace <simona at jlab.org>
Subject: Re: Pulser type

Hello Simona,


Can you send me a picture of the rear panel of the signal generator.
I'm trying to see if it has a GPIB connector for remote interface.
I checked that the model has been discontinued. I also check it might be compatible to be remotely controlled with LabVIEW.


Thanks,
Pablo
________________________________
From: Simona Malace <simona at jlab.org>
Sent: Tuesday, February 20, 2024 11:31 AM
To: Pablo Campero Rojas <campero at jlab.org>
Subject: Pulser type

Hi Pablo

I attach a pic with the pulser type I have.

Thanks.

Simona

Get Outlook for Android<https://aka.ms/AAb9ysg>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla_lappd/attachments/20240226/b6b295d2/attachment.html>