[dsg-halla_solid] CLEO connectors

[Pablo Campero Rojas]

Hello Steven,

 Let me know when you logged out Phycad58 so I can proceed to hide these temperature sensors.

--Pablo
________________________________
From: Steven Lassiter <lassiter at jlab.org>
Sent: Monday, December 12, 2022 10:30 AM
To: Pablo Campero Rojas <campero at jlab.org>
Subject: Re: CLEO connectors

Hello Pablo,

The temp sensors to mask would be:
CU1
CU2
AST1a
AST2
AST4

Also
PT-102 CL_A
PT-102 CL_B

Steven
________________________________
From: Pablo Campero Rojas <campero at jlab.org>
Sent: Monday, December 12, 2022 7:52 AM
To: Steven Lassiter <lassiter at jlab.org>; dsg-halla_solid at jlab.org <dsg-halla_solid at jlab.org>
Cc: Whit Seay <wseay at jlab.org>
Subject: Re: CLEO connectors

Hello Steven,

The cable was fabricated before the resistor box (built by Ellen) and the requested cable specifications were provided, one of this specifications sent was Drawing A00000-16-03-0401, which showed the cable connector pins that we had on the cable.

Now to match the resistor box connector, as Mindy mentioned, she can change the pins on the male connector at the cable, we have extra female pins that can be swapped.


With regards to temperature sensors, do you want me to masked the five temperature sensors (TS_6, TS_24, TS_9, TS_7,TS-33) on the HMI screen? Or will we wait to see if some of them can be recovered?


-Pablo
________________________________
From: Steven Lassiter <lassiter at jlab.org>
Sent: Sunday, December 11, 2022 5:08 PM
To: dsg-halla_solid at jlab.org <dsg-halla_solid at jlab.org>; Pablo Campero Rojas <campero at jlab.org>
Cc: Whit Seay <wseay at jlab.org>
Subject: CLEO connectors

Hello Pablo,

The Voltage tap connector at the end of the cable coming from the control rack to the resistor box is configured incorrectly. It seems that pins were used in a socket connector.
See attached photo.
This needs to be corrected asap so that the complete circuit can be made up and the quench detector channels tuned.

Also, some of the temperature sensors should be masked on the HMI screens as they will not be used.
We discussed this on Friday.

The following temperature sensors had issues that prevents them from being used in a four wire configuration or not all.

TS_6
TS_24
TS_9
TS_7
TS-33

Heidi is working on recovering as many as she can. These sensors were tested and found to be viable at the 25 pin connectors and then through to the 10 pin connectors. Somewhere between the 10 pin connectors and the I/O channel, the wires are either open or mis-wired.

I have updated the excel spreadsheet and the.acd file over the weekend. Will send the excel file to you on Monday.

Steven



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla_solid/attachments/20221212/f699c40f/attachment.html>