[Dsg-halla_magnets] Turret D-Sub Repairs

[Brian Eng]

Whit,

Was going over the disconnected wires with Mindy and we've found 5 wires that need to be reattached, however one of them doesn't have a label and I'm 99% sure that it will end up being the wire labeled as 102 that goes to E2-D on the instrumentation flange.

That was one of the wires that Mindy found when disconnecting the small flanges that isn't in the Oxford drawings at all (that I could find).

Any suggestions on what to do with that wire? Just put some heat shrink on it? I suspect it goes on either N1 or N2, most likely N1 between pins 10 and 13 but it isn't obvious from the connector which if any of those pins would be the correct one as nearly all the unused ones have some sort of solder on them.



Also the AST 2 sensor has been lost. The wires are there (bundle 92 - Br/Br/Gy), but no sensor is attached.
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halla_magnets/attachments/20220906/cfb7d517/attachment.html>