[Dsg-dc] gas shed cRio

[Marc McMullen]

I went over to the gas shed to investigate. All MFC were on, so I rebooted the cRIO. The R3 manifold readback is still not showing pressure. The current pressure in mix tank 1 is 86.8. This concurs with the gauge on the tank. 

Marc McMullen 
Physics Division 
Detector Support Group 
7738 


From: "Brian Eng" <beng at jlab.org> 
To: "Morgan Cook" <mcookiv at jlab.org> 
Cc: "Marc McMullen" <mcmullen at jlab.org>, "dsg-dc" <dsg-dc at jlab.org> 
Sent: Wednesday, June 20, 2018 9:01:24 AM 
Subject: Re: gas shed cRio 

Looks like that cRIO was rebooted ~5 min ago before I could look into what/if anything was wrong. 

----- Original Message ----- 
> From: "Morgan Cook" <mcookiv at jlab.org> 
> To: "Marc McMullen" <mcmullen at jlab.org>, "Brian Eng" <beng at jlab.org> 
> Cc: "dsg-dc" <dsg-dc at jlab.org> 
> Sent: Wednesday, June 20, 2018 7:52:18 AM 
> Subject: gas shed cRio 

> Gentlemen, 
> 
> It looks like there's an issue with the gas shed cRio. All of the mfcs show an 
> open valve position, but no flow through them; the R1-2 control pressure is not 
> reading. 
> 
> -Morgan 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_dc/attachments/20180620/7e65fe70/attachment-0002.html>