[Dsg-ft] Meeting minutes for chiller and humidity sensor

[Amrit Yegneswaran]

thanks for the good meeting minutes amanda. 

if: 1.4.2 analog card does work, why is the Bi-Ra needed? 
or are you implying that the analog card works in that: once the analog input is enabled the chiller doesn't become a heater. 

w.r.t probable condensation issues 
has a drip tray been installed as a safety measure. 

peter mentioned that to preclude the condensation issue altogether, one could wrap the pipe wrap around the tubes in a heat tape to provide a temp. always above dew point. 
this is a good suggestion. 
amrit 





From: "Amanda Hoebel" <amandah at jlab.org> 
To: dsg-ft at jlab.org 
Sent: Monday, August 14, 2017 10:49:55 AM 
Subject: [Dsg-ft] Meeting minutes for chiller and humidity sensor 

Hello, 

Attached are the meeting minutes from this morning's meeting to discuss the chiller temperature problem and the request for a third humidity sensor for the calorimeter. 

Regards, 
Amanda 
_______________________________________________ 
Dsg-ft mailing list 
Dsg-ft at jlab.org 
https://mailman.jlab.org/mailman/listinfo/dsg-ft 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_ft/attachments/20170814/aa067566/attachment-0002.html>