[Dsg-ft] Nitrogen pipes

[George Jacobs]

I was able to connect the outlet of the MFM, mass flow meter transducer, 
to the cal N2 supply line.

I was unable to locate the flow control rotameter with valve. So, it was 
not connected.

George


On 07/14/2017 02:18 PM, Raffaella De Vita wrote:
> Hi George,
> both inlet and outlet lines are lying close to the flowmeter on the 
> floor under the compact rio chassis. Pipes are labeled. The inlet 
> pipes come from the L1 space frame from the location that you showed 
> to Marco. The pipe is labeled on that side too.
> Thanks a lot,
>     Raffaella
>
> George Jacobs wrote:
>> Which line does the inlet of the flow meter attach to?
>>
>>
>> On 07/14/2017 08:54 AM, Raffaella De Vita wrote:
>>> Hi Amanda,
>>> We have installed the nitrogen lines for the ftcal purge. The still 
>>> have to be connected to the main line in the hall but they are ready 
>>> to be connected to the flow meter. Will you take care of that?
>>> Also, the flow meter is now sitting on the floor but it would be 
>>> nice to have a small panel to attach it to the rack . Would that be 
>>> possible?
>>> Thanks ,
>>> Raffaella
>>>
>>> _______________________________________________
>>> Dsg-ft mailing list
>>> Dsg-ft at jlab.org
>>> https://mailman.jlab.org/mailman/listinfo/dsg-ft
>>
>

-- 
George Jacobs
Physics Detector Support Group
Jefferson Lab (TJNAF)
STE 12
12000 Jefferson Ave.
Newport News, VA 23606

(office) 757-269-7115

(cell)   757-876-0480

(email) jacobsg at jlab.org

(website) https://userweb.jlab.org/~jacobsg