[Dsg-ft] [New Logentry] FTT condensation interlock tripped

[Eugene Pasyuk]

I somehow managed to reset this latched interlock. I turned chiller back on. 


-Eugene 

----- Original Message -----

From: "Raffaella De Vita" <Raffaella.Devita at ge.infn.it> 
To: dsg-ft at jlab.org, amandah at jlab.org 
Cc: pasyuk at jlab.org 
Sent: Friday, September 21, 2018 1:53:19 AM 
Subject: Fwd: [New Logentry] FTT condensation interlock tripped 



Hi Amanda, 
As you can see from the attached logbook entry there was a trip of the ft interlocks caused by the condensation sensor that was added last year. The GUI shows under/over limit from what is hard to understand what’s wrong with it. The sensor is actually not installed at the moment but is located in the cRio rack under the crate. Since it is not used, we can disable it but when I did, the “reset latched errors” button still didn’t clear the errors. 
Can you check? 
For now we would like to keep the sensor disabled and re-enable the Hv, Lv and Chiller to be able to operate the detector. 
Thanks, 
Raffaella 

Inizio messaggio inoltrato: 




Da: pasyuk at jlab.org 
Data: 21 settembre 2018 03:50:03 CEST 
A: raffaella.devita at ge.infn.it , battaglieri at ge.infn.it 
Oggetto: [New Logentry] FTT condensation interlock tripped 




<blockquote>



FTT condensation interlock tripped 



    * Edit 
    * Delete 


Lognumber 3595999 . Submitted by pasyuk on Thu, 09/20/2018 - 21:45 . Logbooks: 	FT HBLOG 

We got this error and it seems a bit strange. The humidity is about 5%. The first tab on hardware interlocks window shows "condensation status" Overlimit. On the second tub left most status shows condensation status Under limit. Latched interlocks show " Ok. It might be real, or it might be some issue with sensor or may be with PLC. 
Anyhow, for the time being I turned off the chiller.May be it clears if calorimeter warms up. 

</blockquote>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_ft/attachments/20180921/be9cfc99/attachment-0002.html>