Hi,
Perhaps we could use the compressed air line, unfortunately this could contain moisture ,oil and junk.Or one could use canned air.
Amrit
----- Original Message -----
From: George Jacobs 
To: Raffaella De Vita 
Cc: dsg-ft@jlab.org
Sent: Fri, 05 May 2017 16:02:30 -0400 (EDT)
Subject: Re: [Dsg-ft] nitrogen purge

This will require a pressure systems design authority (DA) to perform the analysis, fill out the documentation, and make a determination if it can be used. 

This will require a P&I diagram and a spreadsheet listing all components to be used in the test setup, pressure and volume of gas, etc. First you need to find a pressure systems DA and ask them if they will be the DA for your test setup. 

I know it seems like much to do about nothing, but our hands are tied. The ASME pressure system requirements must be followed. 

George 


From: "Raffaella De Vita"  
To: "George Jacobs" , dsg-ft@jlab.org 
Sent: Friday, May 5, 2017 12:11:40 PM 
Subject: nitrogen purge 

Dear George, 
we are in the process of re-closing the forward tagger calorimeter to 
prepare for this summer installation. We would like to test quickly the 
circuit for the nitrogen purge using a nitrogen bottle in the EEL 
building. It would be a very quick test just to make sure the circuit is 
mounted correctly before proceeding with the rest of the assembly 
procedure. Would it be possible to do it today? 
Sorry for the very short notice! 
Best regards, 
Raffaella 

-- 
George Jacobs 
Physics Detector Support Group 
Jefferson Lab 
12000 Jefferson Ave. 
STE 12 
Newport News, VA 23606 

(office) 757-269-7115 

(cell) 757-876-0480 

(email) jacobsg@jlab.org 

(website) https://userweb.jlab.org/~jacobsg