[Dsg-hallb_magnets] Updates to DBox,- Torus PLCs

[Nicholas Sandoval]

Hi Pablo,

As we discussed yesterday it is OK to move forward with the change.  And as a reminder please be mindful of the in use control loops on the DBX and Torus for maintaining 80K, it is best to go online with both systems and save that as your starting point configuration.  In that way we keep any changes to PID loops from EPICs that may have been made since the last save.

Please wait to implement the valve interlock updates for Solenoid on the DBX routine until after lunch.  That will give us a couple of hours to be sure that Torus cooling is still stable.  

Hi All,

We anticipate no problems from the IP change in each system, should be offline for less then 2-3 minutes for each.  


Best REgards,

Nick

----- Original Message -----
From: "Ruben Fair" <rfair at jlab.org>
To: "Pablo Campero Rojas" <campero at jlab.org>
Cc: "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org>
Sent: Tuesday, December 20, 2016 9:15:55 AM
Subject: Re: [Dsg-hallb_magnets] Updates to DBox,- Torus PLCs

Pablo - please check with Nick and Denny first. 

Regards 

Ruben 

On Dec 20, 2016, at 8:18 AM, Pablo Campero < campero at jlab.org > wrote: 




Hello Ruben and Renuka; 

I need to download the new routine that I programmed to set the Interlocks valves (required by the Solenoid) into the the DBox PLC. 
In addition to this, is needed change the configurations for the IP Address for the DBox and Torus PLCs to be able to set the communication with the Solenoid PLC. 

Please let me know if I can go ahead with this updates for both PLCs (DBox and Torus). 

Best Regards 
Pablo Campero 




_______________________________________________ 
Dsg-hallb_magnets mailing list 
Dsg-hallb_magnets at jlab.org 
https://mailman.jlab.org/mailman/listinfo/dsg-hallb_magnets 

_______________________________________________
Dsg-hallb_magnets mailing list
Dsg-hallb_magnets at jlab.org
https://mailman.jlab.org/mailman/listinfo/dsg-hallb_magnets