[Dsg-hallb_magnets] TR817A2 at 325 K, LV cRIO restarted.

[Glenn Young]

Dear Tyler,
Do we have statistics of which Cernox exhibit the 325k error? I.e. is it randomly distributed or are there a few specific ones that are most like to have the problem?
Thanks, Glenn

----- Original Message -----
From: "Tyler Lemon" <tlemon at jlab.org>
To: "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org>, "Ramakrishna Bachimanchi" <bachiman at jlab.org>
Sent: Wednesday, April 19, 2017 4:10:47 PM
Subject: [Dsg-hallb_magnets] TR817A2 at 325 K, LV cRIO restarted.

Hello, 

TR817A2 was at 325 K this afternoon. The Torus LV cRIO was reset and the Cerenox now reads 4.75 K. 

I did not get a screen shot of the raw data from the error. I initially connected to the LV cRIO from a different PC than usual. This PC did not have the required LabVIEW packages installed, causing an error when connecting to the cRIO. This error stopped the program. After moving to the PC normally used for Hall B LabVIEW, the program was successfully restarted following the normal restart procedure. 

Best regards, 
Tyler 

_______________________________________________
Dsg-hallb_magnets mailing list
Dsg-hallb_magnets at jlab.org
https://mailman.jlab.org/mailman/listinfo/dsg-hallb_magnets