[Dsg-hallb_magnets] Additional Hall sensors in the Solenoid Magnet

[Renuka Rajput-Ghoshal]

Thanks Pablo

Renuka


----- Original Message -----
From: "Pablo Campero" <campero at jlab.org>
To: "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org>
Sent: Friday, February 10, 2017 3:03:49 PM
Subject: Re: [Dsg-hallb_magnets] Additional Hall sensors in the Solenoid	Magnet

Hi Renuka, 
The additional two Hall sensors (HS2 and HS3) were added in the Solenoid PLC program. 

Regards, 
Pablo 


From: "Tyler Lemon" <tlemon at jlab.org> 
To: "Probir Ghoshal" <ghoshal at jlab.org>, "Renuka Rajput-Ghoshal" <renuka at jlab.org>, "Scot Spiegel" <spiegel at jlab.org>, "Pablo Campero" <campero at jlab.org>, "Wesley Moore" <wmoore at jlab.org>, "Ruben Fair" <rfair at jlab.org>, "dsg-hallb magnets" <dsg-hallb_magnets at jlab.org> 
Sent: Wednesday, February 8, 2017 10:26:29 AM 
Subject: Re: Additional Hall sensors in the Solenoid Magnet 

Hello Renuka, 
The Solenoid LV cRIO program has been updated to add the two new Hall Sensors. I will deploy the updated program within the next few minutes. 

Best regard, 
Tyler 


From: "Probir Ghoshal" <ghoshal at jlab.org> 
To: "Renuka Rajput-Ghoshal" <renuka at jlab.org> 
Cc: "Scot Spiegel" <spiegel at jlab.org>, "Pablo Campero" <campero at jlab.org>, "Tyler Lemon" <tlemon at jlab.org>, "Wesley Moore" <wmoore at jlab.org>, "Ruben Fair" <rfair at jlab.org> 
Sent: Wednesday, February 8, 2017 9:36:14 AM 
Subject: Re: Additional Hall sensors in the Solenoid Magnet 

I do not have the electronic data but there are only about 5 points and error calibration mV/ kG is available and is linear... 
We can use that... 

Sent from my iPhone 

> On Feb 8, 2017, at 9:21 AM, Renuka Rajput-Ghoshal <renuka at jlab.org> wrote: 
> 
> Hello All, 
> It is decided to install 3 Hall sensor instead of previously decided 1 Hall sensor. 
> The master instrumentation list has been updated, Rama has assigned the LV chassis channel numbers. 
> 
> Scot, please update the drawing and make sure we have all the necessary parts to make the cables. Please, also let Mark Lester know about required cables for these additional Hall sensors. 
> 
> Pablo, please update your PLC tag list and your PLC software to accommodate these additional Hall sensors. 
> 
> Wesley, please update your Magnet Power Supply EPICS screen to show these two additional Hall sensors. 
> 
> Probir, do you have the required calibration data for these Hall sensor in electronic format. 
> 
> All, please let me know the estimated time to complete these tasks. 
> 
> Thanks 
> Renuka 


_______________________________________________
Dsg-hallb_magnets mailing list
Dsg-hallb_magnets at jlab.org
https://mailman.jlab.org/mailman/listinfo/dsg-hallb_magnets