[Dsg-hallb_magnets] Z support Coil D

[Tyler Lemon]

Hello Probir, 

I can meet you in Hall B at about 1:45PM. Would you be in Hall B on space frame level 2? 

Best regards, 
Tyler 


From: "Probir Ghoshal" <ghoshal at jlab.org> 
To: "Tyler Lemon" <tlemon at jlab.org> 
Cc: "Ruben Fair" <rfair at jlab.org>, "Dave Kashy" <kashy at jlab.org> 
Sent: Thursday, January 5, 2017 12:07:32 PM 
Subject: Re: Z support Coil D 

Tyler 

Could we meet in the hall..at 130 pm today. 
Regards 
Probir 

----- Original Message ----- 
From: "Probir Ghoshal" <ghoshal at jlab.org> 
To: "Ruben Fair" <rfair at jlab.org> 
Cc: "Dave Kashy" <kashy at jlab.org>, "Nick Sandoval" <sandoval at jlab.org>, "Denny Insley" <dinsley at jlab.org>, "Tyler Lemon" <tlemon at jlab.org> 
Sent: Thursday, January 5, 2017 9:57:45 AM 
Subject: Re: Z support Coil D 

I will have disconnect again for longer period to check the air side connector. 
The vacuum side on the ccm reads all okay be find the connector to be loose on the air side the incorrect know to disconnect the connector... 
Need to open the connector and check and track the cable routing .... 
Regards Probir 

Sent from my iPhone 

> On Jan 5, 2017, at 9:30 AM, Probir Ghoshal <ghoshal at jlab.org> wrote: 
> 
> I will disconnect the connector on the z support coil d temp and agreed with Dave K for about 10 min staring 930 hrs now. 
> Tyler may I ask you to please put this in the log for record. 
> 
> Regards 
> Probir 
> 
> Sent from my iPhone 
> 
>> On Jan 4, 2017, at 5:35 PM, Ruben Fair <rfair at jlab.org> wrote: 
>> 
>> Probir, 
>> 
>> Tomorrow can you check the resistance of this strain gauge? 
>> 
>> Regards 
>> 
>> Ruben 
>> 
>>> On Jan 4, 2017, at 5:33 PM, Dave Kashy <kashy at jlab.org> wrote: 
>>> 
>>> I noticed that the Z support on coil D has one strain gage (SG817D5)not reading a reasonable value. Now it reads -5200lb previously it read ~-800lbs. Did a SG get loose or is there a wiring problem? 
>>> 
>>> This seemed to start ~11/30 and got real bad around 12/9 
>>> It does not seem real because the opposing SG does not show any similar changes. 
>>> 
>>> 
>>> Dave 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_magnets/attachments/20170105/9a5b1555/attachment.html>