[Dsg-hallb_magnets] Torus controlled ramp down, Fast DAQ cRIO terminal server

[Tyler Lemon]

Hello,


We did not need to swap cRIOs this evening. Rather than putting the spare magnet cRIO back at Brian's desk, I'm putting it in the spares cabinet in the Hall B Counting house.


It is on one shelf up from the bottom in an anti-static bag.


Tyler

________________________________
From: Dsg-hallb_magnets <dsg-hallb_magnets-bounces at jlab.org> on behalf of Tyler Lemon <tlemon at jlab.org>
Sent: Sunday, December 9, 2018 9:29:33 PM
To: dsg-hallb magnets
Subject: [Dsg-hallb_magnets] Torus controlled ramp down, Fast DAQ cRIO terminal server


Hi,


Amanda asked me to help with the Torus controlled ramp. I tried rebooting the cRIO through NI MAX, the LabVIEW project, and the MOXA terminal server.


I'm not sure if I got the sequence of commands correct to reboot with the MOXA terminal server.


I stopped the logging  and telnet-ed into the terminal server port 15  for the Torus FastDAQ cRIO.


The telnet command I used was "telnet hallb-moxa6 4015"


It said it connected successfully, but nothing happened when I typed "reboot".


If these are the correct steps, it seems to me the cRIO is dead and needs to be replaced like what has happened a few times in the past.


Best regards,

Tyler


-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_magnets/attachments/20181210/0dac82a2/attachment-0001.html>