<html><body><div style="font-family: times new roman,new york,times,serif; font-size: 12pt; color: #000000">Hello Marco,<br><br>All electronic panel sensors would be on the "Sector 1 Electronic Panel Interlocks" page.<br><br>The only sensors on the "Sector 1 Nitrogen Interlocks" page are the ones epoxied in place inside RICH's nitrogen volume.<br><br>Best regards,<br>Tyler<br><br><hr id="zwchr" data-marker=""><div data-marker=""><b>From: </b>"Mirazita Marco" <Marco.Mirazita@lnf.infn.it><br><b>To: </b>"Tyler Lemon" <tlemon@jlab.org><br><b>Cc: </b>"dsg-rich" <dsg-rich@jlab.org><br><b>Sent: </b>Friday, December 8, 2017 6:08:50 PM<br><b>Subject: </b>Re: [Dsg-rich] dual interlock chassis installed in EEL 124<br></div><br><div data-marker="">Hi Tyler,<br>just to be sure before we start, where I find the humidity and <br>temperature sensors 3,5,7 that are installed in the electronic panel?<br>In the "Sector 1 nitrogen panel interlocks" or in the "Sector 1 <br>electronic panel interlocks"?<br>Thank you<br>Marco<br><br><br>Il 2017-12-08 17:48 Tyler Lemon ha scritto:<br>> Hello,<br>> <br>> The second interlock cRIO chassis has been installed in EEL 124.<br>> <br>> All interlock sensors that are not epoxied into RICH are read by this<br>> chassis. Any sensor placed into the electronic panel will be read by<br>> the second chassis.<br>> <br>> The labels on the cables and what sensors they read for the second<br>> interlock chassis are:<br>> <br>> Label on cable, T1, T2, H1, H2<br>> <br>> 1, Temperature #1, Temperature #2, Humidity #1, Humidity #2<br>> <br>> 2, Temperature #3, Temperature #4, Humidity #3, Humidity #4<br>> <br>> 3, Temperature #5, Temperature #6, Humidity #5, Humidity #6<br>> <br>> 4, Temperature #7, Temperature #8, Humidity #7, Humidity #8<br>> <br>> 5, Temperature #9, Temperature #10, Humidity #9, Humidity #10<br>> <br>> 6, Temperature #11, Temperature #12, Humidity #11, Humidity #12<br>> <br>> 7, Temperature #13, Temperature #14, Humidity #13, Humidity #14<br>> <br>> 8, Temperature #15, Temperature #16, Humidity #15, Humidity #16<br>> <br>> In the nitrogen panel cRIO, the temperature sensors connected<br>> correspond to the same numbering scheme as the humidity sensors.<br>> <br>> I was not able to add the calibration constants for any of the<br>> electronic panel humidity sensors. I will add them on Monday.<br>> <br>> To get the wiring for the relays that disable the CAEN, I had to<br>> remove the override switch's wiring as the ferrules were too large to<br>> accommodate the new wiring for the second cRIO. I will also rewire<br>> this on Monday.<br>> <br>> Best regards,<br>> <br>> Tyler<br>> <br>> _______________________________________________<br>> Dsg-rich mailing list<br>> Dsg-rich@jlab.org<br>> https://mailman.jlab.org/mailman/listinfo/dsg-rich<br></div></div></body></html>