[Dsg-rtpc] RTPC/BONuS12 Testing

[Walt Akers]

Yes it is.

Walt

Marc Mcmullen wrote:
> Hi Walt,
>
> I'm available anytime except Wednesday from 1 to 3:30. I also am 
> planning to go visit W&M on Thursday in the afternoon. Other than 
> that, I am available. Is tomorrow at 9:30 ok?
>
> Marc
> ------------------------------------------------------------------------
> *From:* Walt Akers <akers at jlab.org>
> *Sent:* Monday, February 18, 2019 3:39 PM
> *To:* Marc Mcmullen; Sebastian Kuhn; dsg-rtpc at jlab.org
> *Cc:* Patrizia Rossi; Ed Folts
> *Subject:* Re: RTPC/BONuS12 Testing
> Hey Marc:
>
> I've been in discussions with Sebastian and Stepan regarding where the 
> work will be
> conducted.  MOst likely, it will be in the rear of EEL-125 (clean room 
> service area),
> so that the has exhaust can be channeled through an existing port in 
> the wall.
>
> I'll be happy to walk through the area with you at your convenience.
>
> Walt
>
> Marc Mcmullen wrote:
>> Hi Sebastian,
>>
>> I just wanted to contact you in preparation for the delivery and 
>> testing of the RTPC, DMS, and any supporting systems for the 
>> detector, to the EEL building and, subsequently, in Hall B. Some of 
>> the details involved were discussed during the meeting on 02/07 
>> <https://www.jlab.org/div_dept/physics_division/dsg/meeting_minutes/Hall_B/Gas_Systems/2019-02-07%20RTPC%20Gas%20Controls%20Meeting.pdf>.
>>
>> In an effort to minimize any impact to the schedule, provided by 
>> Mohammad, the DSG manager has determined that the RTPC/BONuS12 group 
>> should develop a document which will cover the entire scope of 
>> delivery, set up, and testing of all equipment prior to delivery to 
>> the EEL building. That plan should include all the necessary 
>> procedures to safely set up the equipment and run any required 
>> functionality or verification tests. Once complete, the 
>> plan/procedures should be submitted to Ed Folts (Physics Division 
>> Safety Officer), who can then further assist by informing you of the 
>> safety documentation, training, and approvals which will need to be 
>> completed prior to delivery and/or set up. In addition to Ed, Walt 
>> Akers (Physics Division Project Management) should be contacted in 
>> order to coordinate a suitable testing area in the EEL.
>>
>> I am planning another meeting for the end of February to discuss 
>> plans for Gas Controls development, in the interim I will contact 
>> Carlos in order to arrange a DSG visit to check the progress of the 
>> gas panel at W&M. If possible, could you provide a status for the 
>> installation/testing plan during the meeting, I am tentatively 
>> planning to meet on 2/28 if all parties are available.
>>
>> Regards,
>> Marc
>>
>

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_rtpc/attachments/20190218/80d59c8e/attachment-0002.html>