[dsg-svt] SVT leak sensor

[Tyler Lemon]

Yuri,

The leak sensor was unseated from its base, causing it to continuously trip.

We had to tape the sensor down to get it to stay seated because the sensor is placed in a small cup that doesn't allow it to fully sit flat on its own because of the sensor's cable.

We verified the sensor still works by placing a wet paper towel over it. We dried the sensor off and made sure it was correctly seated before leaving.

If this keeps happening, during a run, the interlock may need to be temporarily disabled until it can be more permanently affixed to the cup.

Tyler
________________________________
From: dsg-svt <dsg-svt-bounces at jlab.org> on behalf of Peter Bonneau <bonneau at jlab.org>
Sent: Wednesday, November 27, 2019 10:35 AM
To: Yuri Gotra <gotra at jlab.org>; dsg-svt <dsg-svt at jlab.org>
Subject: Re: [dsg-svt] SVT leak sensor

Pablo, Aaron, & Tyler are going to the hall to check the sensor.

Peter

________________________________
From: dsg-svt <dsg-svt-bounces at jlab.org> on behalf of Yuri Gotra <gotra at jlab.org>
Sent: Wednesday, November 27, 2019 10:25 AM
To: dsg-svt <dsg-svt at jlab.org>
Subject: [dsg-svt] SVT leak sensor

SVT leak sensor failed (interlock signal with no liquid in the box),
could you please check. The hall will be closed by noon today. Thank you

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_svt/attachments/20191127/127a1134/attachment-0002.html>