[dsg-svt] SVT leak sensor

[Amrit Yegneswaran]

good job tyler,
have a nice break.


________________________________
From: dsg-svt <dsg-svt-bounces at jlab.org> on behalf of Yuri Gotra <gotra at jlab.org>
Sent: Wednesday, November 27, 2019 11:01 AM
To: Tyler Lemon <tlemon at jlab.org>; Peter Bonneau <bonneau at jlab.org>; dsg-svt <dsg-svt at jlab.org>
Subject: Re: [dsg-svt] SVT leak sensor

Thank you Tyler

On 11/27/19 11:00 AM, Tyler Lemon wrote:
> Yuri,
>
> The leak sensor was unseated from its base, causing it to continuously trip.
>
> We had to tape the sensor down to get it to stay seated because the sensor is
> placed in a small cup that doesn't allow it to fully sit flat on its own because
> of the sensor's cable.
>
> We verified the sensor still works by placing a wet paper towel over it. We
> dried the sensor off and made sure it was correctly seated before leaving.
>
> If this keeps happening, during a run, the interlock may need to be temporarily
> disabled until it can be more permanently affixed to the cup.
>
> Tyler
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallb_svt/attachments/20191127/3fa8b78c/attachment-0002.html>