[Dsg-hallc_controls] PT2026 Remote Reset

[Steve Lassiter]

Hi,

 The wiring is made up and the power cycle relay is on HMS_Dipole:2:O.ch11.

Steven

----- Original Message -----
From: "Brian Eng" <beng at jlab.org>
To: "dsg-hallc controls" <dsg-hallc_controls at jlab.org>
Sent: Wednesday, August 15, 2018 9:28:43 AM
Subject: Re: [Dsg-hallc_controls] PT2026 Remote Reset

Hi Steve,

Has this been connected yet?

The NMR communication is frozen again so it would be a good opportunity to make sure we can actually get it up and running remotely via the PLC.

If you don't think it will be connected soon we'll just manually reset it so that way we can test the NMR when the dipole is ramped today since we missed the ramp yesterday.

Thanks

----- Original Message -----
> From: "Brian Eng" <beng at jlab.org>
> To: "dsg-hallc controls" <dsg-hallc_controls at jlab.org>
> Sent: Monday, August 13, 2018 5:18:03 PM
> Subject: [Dsg-hallc_controls] PT2026 Remote Reset

> Hi Steve,
> 
> We ran the cable from the NMR to the HMS dipole rack. See the attached picture,
> it is coiled up and the ferrules are taped.
> 
> It was verified to work when the NMR had gotten stuck again, so it is definitely
> needed.
> 
> Let us know when it's connected and to which channel.
> 
> Thanks
_______________________________________________
Dsg-hallc_controls mailing list
Dsg-hallc_controls at jlab.org
https://mailman.jlab.org/mailman/listinfo/dsg-hallc_controls