[Dsg-hallc_controls] Hall C PLC tasks report

[Brian Eng]

A few quick comments about the bullets in Pablo's report.

While he was able to get v16 to work in Windows 10 it isn't supported by Rockwell.
If there are any problems that will be the first thing they blame, plus I suspect it will have fewer/if any updates.
The PLCs still need to be upgraded to v20 as it is officially supported on Windows 10.

So far the PT2026 has been working well when the field is < ~1.4 T
It still has a lock from yesterday when they went from ~1.4 to ~1.3
I'm not sure how common the 1.8 T fields from the beginning of the run are.
However, the fact that the 2025 tracked up to 1.8 while the 2026 didn't is concerning.

----- Original Message -----
> From: "Pablo Campero" <campero at jlab.org>
> To: "dsg-hallc controls" <dsg-hallc_controls at jlab.org>
> Cc: "rossi patrizia" <rossi at jlab.org>
> Sent: Friday, October 5, 2018 5:21:20 PM
> Subject: [Dsg-hallc_controls] Hall C PLC tasks report

> Hello,
> 
> I have attached the DSG's weekly report for Hall C-PLC tasks.
> 
> Regards,
> Pablo