[Dsg-hallc_controls] Ethernet on HMS

[Steven Lassiter]

What I found that works is that I have to reboot Skylla7 after downloading a project to the PLC.


There is a service that needs to be stopped and restarted and the only way I  can get it to work is to reboot Skylla7


HMS_controls_V22.acd is the current project running and it has the quad MOL routine.


HMI is back up and running


Steven

________________________________
From: Brian Eng
Sent: Thursday, January 24, 2019 3:18:06 PM
To: Steven Lassiter
Cc: dsg-hallc controls
Subject: Re: [Dsg-hallc_controls] Ethernet on HMS


Nothing looks out of place on any of the module configurations (both redundancy and ethernet look okay) in RSLinx and RSLogix.


Since we can't run anything with the HMI I'm not sure what else there is to do from our end. Maybe it's an issue with FactoryTalk?


Perhaps you can roll back to the previous version of the code if that's all that was changed?

________________________________
From: Dsg-hallc_controls <dsg-hallc_controls-bounces at jlab.org> on behalf of Brian Eng <beng at jlab.org>
Sent: Thursday, January 24, 2019 2:54:46 PM
To: Steven Lassiter
Cc: dsg-hallc controls
Subject: Re: [Dsg-hallc_controls] Ethernet on HMS

Basically both modules should have the same configuration, so they're setup to use IP swapping.

You should be able to see it in RSLinx (I just checked and they still are the same).

> On Jan 24, 2019, at 2:10 PM, Steven Lassiter <lassiter at jlab.org> wrote:
>
> Hi,
>
>  What settings were made on the ethernet card for the HMS?
> I tried to upload a revised program onto the HMS and now the HMI is not working.
>
> Steven

_______________________________________________
Dsg-hallc_controls mailing list
Dsg-hallc_controls at jlab.org
https://mailman.jlab.org/mailman/listinfo/dsg-hallc_controls
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hallc_controls/attachments/20190124/6073f207/attachment-0001.html>