<html><head><style type='text/css'>p { margin: 0; }</style></head><body><div style='font-family: arial,helvetica,sans-serif; font-size: 10pt; color: #000000'>Yes we have a few A/B terminal blocks available. But dont you need to use a terminal block that is already connected to a module? Are you proposing to add a new module?<br><br>Steven<br><br><hr id="zwchr"><div style="color: rgb(0, 0, 0); font-weight: normal; font-style: normal; text-decoration: none; font-family: Helvetica,Arial,sans-serif; font-size: 12pt;"><b>From: </b>"Tyler Lemon" <tlemon@jlab.org><br><b>To: </b>"dsg-hallc controls" <dsg-hallc_controls@jlab.org><br><b>Sent: </b>Thursday, July 5, 2018 9:09:07 AM<br><b>Subject: </b>[Dsg-hallc_controls] connector-to-terminal-block adapter needed for APC UPS relay card<br><br><div style="font-family: times new roman,new york,times,serif; font-size: 12pt; color: rgb(0, 0, 0);"><div>Hello Steve,<br></div><div><br></div><div>To be able to wire the APC UPS's relay card that we installed on Tuesday to the PLC, we will need an adapter to convert the 25-pin d-sub connector to a terminal block.<br></div><div><br></div><div>Would Hall C have one of these adapters on hand?</div><div><br></div><div>If not, I can submit a PR for one.<br></div><div><br></div><div>Best regards,<br></div><div>Tyler<br></div></div><br>_______________________________________________<br>Dsg-hallc_controls mailing list<br>Dsg-hallc_controls@jlab.org<br>https://mailman.jlab.org/mailman/listinfo/dsg-hallc_controls<br></div><br></div></body></html>