[Dsg-halld_plc] Hall D new PointIO system quote

[Tyler Lemon]

Hello Tim and Nick,

Attached is a quote from EECO for the PointIO system that will be added to the FCAL PLC. The total cost is just over $3k.

The quote is for:
One 1734-AENT PointIO Ethernet/IP module
Seven 1734-IE2V voltage input modules
One 1606-XLS120E 24-Volt power supply

The quote is just for Allen Bradley equipment that would need to be bought from EECO.

For the final system to install in Hall D, we would also need a DIN rail, fusing between the power supply and 1734-AENT module, and cabling to the pressure and flow sensors.  These components shouldn't be too expensive and can probably be bought with a credit card like the Watlow chiller controller was. I will gather another cost estimate for these other item, but I have a few questions (below). Some of them may not be able to be answered at the moment due to the work-from-home situation.

  *   Has the location of the PointIO system in Hall D been established?
  *   Is there any documentation on the location of the sensors it will read out?
     *   These first two questions would help determine cable lengths needed.
  *   Does Hall D have any cabling on-hand or should we plan to buy them?

Best regards,
Tyler
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-halld_plc/attachments/20200420/9ba6afc8/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: EECO_Quotation.pdf
Type: application/pdf
Size: 57771 bytes
Desc: EECO_Quotation.pdf
URL: <https://mailman.jlab.org/pipermail/dsg-halld_plc/attachments/20200420/9ba6afc8/attachment-0001.pdf>