[dsg-hdice] DSG-HDice meeting minutes

[Dr. A.M. Sandorfi]

Amanda,

The IBC pump cart was wired by Werth Teachy of the DSG. Why do you not have
the wiring diagram?

Andrew Sandorfi




On 11/8/16, 2:10 PM, "Amanda Hoebel" <amandah at jlab.org> wrote:

> Hi,
> 
> Xiangdong, Mike, Pete, and I had a meeting yesterday to discuss DSG work for
> the HDice group. DSG will continue to work on the software upgrade for the new
> cRIO processor for the pump cart. Since there is no electrical diagram, TSA,
> or repair OSP available for the pump cart, hardware work cannot be performed
> by DSG. DSG was informed that the pump cart will not be used again until
> January.
> 
> The switch heater for the NMR power supply will not be implemented into the
> program until the details of the required interlocks are determined.
> 
> There is presently no corresponding field recorded in the data file for
> lock-in amplifier data. CAENels is working on a firmware modification to allow
> the CT-Box to trigger the lock-in amplifier.
> 
> One of the old Oxford iPS-120 power supplies is no longer working. To
> implement the new Oxford Mercury iPS supply into the NMR program a re-write of
> the program would be needed, as the new power supply has different drivers
> than the old power supply.
> 
> Regards,
> Amanda
> _______________________________________________
> dsg-hdice mailing list
> dsg-hdice at jlab.org
> https://mailman.jlab.org/mailman/listinfo/dsg-hdice