[dsg-hdice] DSG HDice Meeting

[Tyler Lemon]

Hi Xiangdong,

As we discussed, Pablo and I swapped out the 30 V power supply for the 24 V power supply again.

We powered the IGH on and verified that the board is receiving 24 V.

We also annotated the schematic for the IGH to indicate that the 24 V power supply has been reinstalled.

Best regards,
Tyler
________________________________
From: dsg-hdice <dsg-hdice-bounces at jlab.org> on behalf of Peter Bonneau
Sent: Tuesday, July 23, 2019 12:04 PM
To: Xiangdong Wei; dsg-hdice at jlab.org
Subject: Re: [dsg-hdice] DSG HDice Meeting

Hi Xiangdong,

Tyler and Pablo will be over this afternoon to swap back to the 24V IGH power supply.

Regards,

Peter
________________________________
From: Xiangdong Wei <xwei at jlab.org>
Sent: Tuesday, July 23, 2019 11:54 AM
To: Peter Bonneau <bonneau at jlab.org>; dsg-hdice at jlab.org <dsg-hdice at jlab.org>
Subject: Re: [dsg-hdice] DSG HDice Meeting

Hi Peter,

We installed the new gear box on the IGH and tested the related valves. They all work fine, except the temperature of V6 motor was warmer than I expected. To reduce the risk of over heating, we should operate the IGH with 24V supply. Would you please arrange the power supply switching soon? I'll unplug the IGH powers and leave the 24V supply next to IGH.

Thanks,

Xiangdong
________________________________
From: dsg-hdice <dsg-hdice-bounces at jlab.org> on behalf of Peter Bonneau <bonneau at jlab.org>
Sent: Friday, July 19, 2019 9:44 AM
To: dsg-hdice at jlab.org <dsg-hdice at jlab.org>
Subject: [dsg-hdice] DSG HDice Meeting

Hello,

Attached is the meeting minutes from the DSG-HDIce meeting on 07/18/2019.

Regards,
Peter

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/dsg-hdice/attachments/20190723/a25e6038/attachment-0002.html>