<html><body><div style="font-family: times new roman,new york,times,serif; font-size: 12pt; color: #000000"><div data-marker="__QUOTED_TEXT__"><div style="font-family: times new roman,new york,times,serif; font-size: 12pt; color: #000000"><div>Amanda,<br></div><br><div>Thank you for the info, I'll take a look of it either today or tomorrow, when I am not in the Hall-B collaboration meeting.<br></div><br><div>On the NMR field ramping: There was 1 gauss (0.0001Tesla) short on the 3rd sweep during the test last night. (It was set to 0.6008T but not 0.6007T as shown in the attached picture.) I haven't had a chance to see how often it happens yet.<br></div><br><div>Thanks,<br></div><br><div>Xiangdong<br></div><br><div><p><em><span style="FONT-FAMILY: courier new,courier,monaco,monospace,sans-serif"><strong>Xiangdong Wei</strong></span></em></p>
<p><em><span style="FONT-FAMILY: courier new,courier,monaco,monospace,sans-serif"></span></em><span style="FONT-FAMILY: courier new,courier,monaco,monospace,sans-serif"><span style="font-size: small;">x-5266</span></span></p></div><br><hr id="zwchr"><div><b>From: </b>"Amanda Hoebel" <amandah@jlab.org><br><b>To: </b>dsg-hdice@jlab.org<br><b>Sent: </b>Tuesday, October 3, 2017 8:52:48 AM<br><b>Subject: </b>[dsg-hdice] NMR set ramp rate<br></div><br><div>Hi Xiangdong,<br><br>I noticed on the power supply manual control section of the NMR program there is a "set ramp rate" feature. I found you can enter in your desired ramp rate and select the OK button beside it before a run is started. Doing this will allow the power supply to ramp to the desired field setting using the new ramp rate once a run is started.<br><br>Regards,<br>Amanda<br>_______________________________________________<br>dsg-hdice mailing list<br>dsg-hdice@jlab.org<br>https://mailman.jlab.org/mailman/listinfo/dsg-hdice</div></div><br></div></div></body></html>