[Eesic] Fwd: iocsb4

[Peter Anthony Francis]

Not sure if we support BELS, but just in case FYI,


-------- Original Message --------
Subject: 	iocsb4
Date: 	Tue, 22 Jan 2013 15:35:35 -0500
From: 	David Wetherholt <wether at jlab.org>
To: 	Kelly Mahoney <mahoney at z.jlab.org>, Pamela Kjeldsen 
<kjeldsen at jlab.org>, Scott Higgins <higgins at jlab.org>, George Lahti 
<lahti at jlab.org>, Pete Francis <francis at jlab.org>



Hi All,

   We have finished debugging the BELS VME cards and found it was showing
the same errors in the teststand. A look at the manual showed a jumper for
setting operating modes in short address space. After setting that jumper...
the address got mapped correctly.

   We set that on both cards, reseated all the VME cards, and rebooted.
All the
BELS screens are showing green and look good. The PLCs are continuing to
read.

   When we were replacing the cards, we noticed the top left pin on the
bottom connector on the second BELS card was broken. If you have a
spare 2536 card, you might consider replacing it.

Dave

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/eesic/attachments/20130123/3c56c38d/attachment-0002.html>