Hi everybody,<br><br>After this afternoon meeting I have some concern about the values for the target thickness especially Carbon.<br><br>In the NIM paper there is a table indicating areal densities as: C = .38 ; Fe = 0.31 ; Pb = 0.16 g/cm2<br>

Simple calculation with Hyupwoo numbers gives 2H = .325 g/cm2<br><br>Then ratios of electrons from the targets in data should give something around: C = 1.17 ; Fe = .95 ; Pb = .49<br>I found with my cuts: C = .91 ; Fe = .96 ; Pb = .46 It is a good agreement except for Carbon!<br>

<br>If I use Hyupwoo numbers for the Carbon areal density, I find the same than in the NIM paper, but I am concerned with the value of 2.267 g/cm3 because graphite seem to have variable density depending on the web site you 
consult, what I could grab was that raw mineral graphite is between 2.09
 and 2.3 g/cm3 but that once treated it can get much lighter (I seen 
1.57, 1.7 and 1.8 in various places). On the NIST web site they use density of 1.7 g/cm3 for graphite and that would lead to an areal density of .29 g/cm2 which give a ratio in data of .90 in agreement with what I observe in data.<br>
<br>-- <br>Raphaël Dupré<br><br><br>Argonne National Laboratory<br><br>Université Claude Bernard Lyon 1<br>