[Eg6_analysis] meeting tomorrow

[hattawy at ipno.in2p3.fr]

Hello all,
   The parameters of the drift paths i have extracted before are by
setting the beam offset (x,y)= (0,0). But after our meeting at jlab, i
knew that the last data cook (epass1v9), has been done by setting the
beam offset (1.55,0.29)mm. So, i changed the simulation with taking
into account the new beam offset, and what you see in the pdf file is
the new drift paths with the red lines are the fitting functions of the
original drift paths without beam offset for the different slices in z.
  If you agree with me, i dont see differences in the drift paths with
this (1.55,0.29)mm offset.

note: page two are the parameters i am using which are the same i have
sent to lamiaa last time.

Best regards,
Mohammad.


> Hello guys,
>
> Sorry for cutting short the meeting. We had to leave because there was
> another meeting in that room. Please, send your comments in the email.
>
> Regards, Stepan
>
> On 2/28/13 11:05 AM, hattawy at ipno.in2p3.fr wrote:
>> Hello everyone,
>>
>>    Is everything is going well with you, or it is just the problem with
>> me.
>>
>> regards,
>> Mohammad.
>>
>>
>>> Hello everyone,
>>>
>>> We will have eg6 meeting tomorrow, February 28, at 10am in F227.
>>> Agenda can be found at -
>>> http://clasweb.jlab.org/rungroups/lowq/wiki/index.php/Meeting_on_February_28_at_10:00am
>>>
>>>
>>> Calling instructions are at -
>>> http://clasweb.jlab.org/rungroups/lowq/wiki/index.php/Agendas_and_Minutes_of_the_meetings#Agendas
>>>
>>>
>>> Stepan
>>> _______________________________________________
>>> Eg6_analysis mailing list
>>> Eg6_analysis at jlab.org
>>> https://mailman.jlab.org/mailman/listinfo/eg6_analysis
>>>
>>
>
>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Driftpaths.pdf
Type: application/pdf
Size: 416904 bytes
Desc: not available
Url : https://mailman.jlab.org/pipermail/eg6_analysis/attachments/20130228/384e3e0e/attachment-0001.pdf