Hi Stepan and all,<br><br>I would like to set up the strategy of the next pass0 cooking based on what we have done earlier <br>on the pass0_v0.<br><br>1. List of output files that have been produced:<br><br> (i) HBOOK files: SEB ntuples and ANAHIST files<br>
(ii) ROOT files : CLASTOOL & H2ROOT ntuples<br>
(iii) BOS files : Bosbanks format<br> (iv) Helicity_correction files<br> (v) LOG files : ASCII format<br><br>In the previous cooking, <b>NONE</b> of these files was saved on SILO. The files (i) and (iv) were saved on the permanent claseg6 work disk. However, all other files were stored on the auto-manageable work <br>
disk. <br><br>In this cooking, shall I produce the same output formats and save them on the same place? <br><br>2. Claseg6 work disk: the process of the same runs list (total of 796 runs) and ~ 10 files of <br>each run (still to be confirmed) would amount approximately 1.8 TB disk space on the permanent <br>
work area (based on 1). For the moment, 88% of a claseg6 disk space is in use and it's partitioned <br>as follow:<br><br> (i) Previous pass0_v0: 1.8 TB <br> (ii) DC_CALIB files : ~ 437 GB ! files used on the DC calibration by Seema <br>
(iii) EC_CALIB files : ~ 387 GB ! files used on EC_time calibration by Bayram<br> (iv) ....Other cooking purpose covering... ~ 200 GB <br> <br>Before launching this new pass I need to clean some disk space, so what shall I do with the <br>
previous cooking outputs? Please let me know if you have any unused data to remove it.<br><br>3. Which farm node shall we use on this cooking; 32 or 64 bit? I was processing recently <br>all the calibration jobs in the 64 bit farm nodes without any problem (at least I didn't hear any <br>
complain from anyone!). <br><br>4. I have updated the icf package with the new modification that FX did by adding a correction <br>on the vertex position. The new source code reside at ~claseg6/pass0_ect/. I will commit the <br>
new changes to the Eg6 CVS branch. The latter doesn't include all the packages that have been <br>modified like seb, icf & trk, is it possible to tag also those packages on the Eg6 branch? <br><br>Best regards,<br>
<br>Lamiaa<br>
<br clear="all">************************************************************<br>* Lamiaa El Fassi email: <a href="mailto:elfassi@jlab.org">elfassi@jlab.org</a><br>* Research Associate @ Rutgers University <br>
* Phone: (757) 269-7011 // Fax: (757) 269-5703 <br>* Jefferson Lab., 12000 Jefferson Ave. <br>* Suite# 4, MS 12H3<br>* Newport News, VA. 23606<br>************************************************************<br>