[Frost] The basic cuts, Energy Correction, and Momentum Correction of FSU in FroST

[Michael Dugger]

Sung,

Thanks for updating the "Standard practices, common practices, and common 
analysis issues for g9a" web page :)

Comments:
* For the z-vertex using GPID (TBTR) you should state what particle is 
being used.

* The CH2 pull angles look OK, but the Butanol lambda angles are 
especially bad. This might be explained by the target magnetic 
holding-field (I think that Eugene and Franz made this sort of statement 
during one of the meetings where you showed these pulls). I added a line 
about this to the wiki (including a link to your webpage).

Let's hope that the holding field corrections get this lambda angle 
problem fixed.

Good job.

Take care,
Michael

On Mon, 1 Nov 2010, Sungkyun Park wrote:

> Hi all,
>
> I have updated the EC and MomC of FSU, we mentioned at the last Friday meeting
>
> 1. The Basic Cut
>  http://www.jlab.org/Hall-B/secure/g9/sungkyun/11-1-10-ZVertex.html
>
> * I compare Z-vertex made in MVRT bank with GPID bank in several cases.
> * I put the basic cuts used to make the z-vertex distribution.
>
> 2. The FSU EC
>  http://www.jlab.org/Hall-B/secure/g9/sungkyun/11-1-10-FSUEC.html
>
> * I put the equation of FSU Energy Correction.
> * I compare FSU-EC with CMU-EC in several cases.
>
> 3. The FSU-MomC
>  http://www.jlab.org/Hall-B/secure/g9/sungkyun/11-1-10-FSUMomC.html
>
> * I put the preliminary version of momentum correction
> * I put the resolution parameters for three kinds of targets, used in the covariance matrix.
>
> If you have some questions or comments, Let me know them
>
> Sungkyun Park
> Florida State University
> _______________________________________________
> Frost mailing list
> Frost at jlab.org
> https://mailman.jlab.org/mailman/listinfo/frost
>