[Frost] Fwd: Slides for BARYONS 2016

[Eugene Pasyuk]

Hi Ross,

A few comments to your slides.
Slide 9: Third bullet in cuts is a bit ambiguous. One can wonder if this is photn in CLAS or beam photon. Clarify.
Slides 10-11: "preliminary" label is not necessary on the missing mass plots.
Slide 12: What is the purpose of this slide? Next slide also show the same. There are also some faded traces of the curves on it. 
Slides 13-14: Specify which PWA solution was used for the curves. What is the difference between "MAID" and "mainz"? Also would be good to add references to previous data you compare with.
Slide 15: second bullet: You have shown F but forget to mention it here.
Third bullet: Large angular coverage is a bit too strong statement especially just after you compared with Mainz data.

-Eugene

----- Original Message -----
> From: "Ross Tucker" <rjtucke at gmail.com>
> To: "frost" <frost at jlab.org>
> Sent: Saturday, May 14, 2016 4:11:54 PM
> Subject: [Frost] Fwd: Slides for BARYONS 2016

> Hi all-
> Please accept my sincere apologies for sending this out so late! It
> was unclear until yesterday that I was going to be able to attend this
> conference. Please find attached a link to my slides for Volker's BARYONS 2016
> conference. These are updated for the results as of my dissertation. I
> would appreciate comments or suggestions.
> 
> Thank you-
> Ross Tucker
> 
> 
> Link: ( http://userweb.jlab.org/~rtucker/asu/baryon2016.pdf )
> _______________________________________________
> Frost mailing list
> Frost at jlab.org
> https://mailman.jlab.org/mailman/listinfo/frost