[G12] G12 Yield

[Paul Eugenio]

Hi Eugene,

Would gflux work fine for small runs (and single files) if timeline was changed permanently to 1000?  


Paul


--
Prof. Paul Eugenio
Florida State University
Department of Physics
Tallahassee, Florida,  USA 32306

(850) 644-2585
eugenio at fsu.edu



On Apr 20, 2011, at 11:22 PM, Eugene Pasyuk wrote:

> I looked into the gflux code and discovered that there is a problem if 
> we run it on entire run at once. The way it is now it has a storage 
> reserved for only 50 intervals. This is fine for single file. However, 
> The whole run in g12 may have over 700 intervals. In that case it will 
> produce the flux for the first 50 intervals.
> 
> The fix is simple, as follows.
> At the beginning of the gflux.c file in the section where some global 
> variables are declared and initialized there is a line:
> 
> int timeline = 50;
> 
> This number should be change to something which is larger than the 
> longest run duration in units of 10 sec. 1000 probably should be enough.
> 
> -Eugene
> 
> mkunkel at jlab.org wrote, On 04/20/11 21:38:
>> Greetings G12,
>> 
>> I had promised the new Yield Plots, however I have found a new bug in the
>> GFlux calculator script.
>> When I run the script, I returns me a higher gflux then what was initially
>> there.
>> I have attached a plot depicting this discrepancy and was wondering if
>> this can get looked into.
>> 
>> Thanks
>> MK
>> 
>> 
>> 
>> _______________________________________________
>> G12 mailing list
>> G12 at jlab.org
>> https://mailman.jlab.org/mailman/listinfo/g12
> _______________________________________________
> G12 mailing list
> G12 at jlab.org
> https://mailman.jlab.org/mailman/listinfo/g12