[Halld-cal] [Halld-tracking-hw] CDC feedthrus and end plate

[Tim Whitlatch]

Hi Gerard,

If this configuration is worked out soon, we can issue a revision and 
have the current vendor do the work also.

Tim

Gerard Visser wrote:
> Hi Tim,
>     No, I think the idea (just as with the pressfit pin socket I 
> selected) is that this part is put on the endplate, and the wire is 
> soldered or crimped into a mating pin. Then just plug these wires in, 
> at the time when the signal cables are plugged into the rubber 
> connector pieces.
>
>     - Gerard
>
> Tim Whitlatch wrote:
>> Does the wire get soldered into the end?
>>
>> Tim
>>
>> Gerard Visser wrote:
>>> Hi Fernando,
>>>     I like that part... I had no idea they existed but yes it seems 
>>> a perfect fit for our requirements. Of course it is slightly larger 
>>> in diameter than the press-fit sockets, but not too bad. Certainly 
>>> much smaller than a screw head and lug.
>>>     Anyway, per Tim's other email we are too late with this 
>>> discussion. Either the thing will work as is (grounded only through 
>>> the metal outer cover of the gas plenum) or else the endplates have 
>>> to be modified post-fabrication.
>>>
>>>     - Gerard
>>>
>>> Fernando J. Barbosa wrote:
>>>> Hi Gerard,
>>>>
>>>> Perhaps this threaded socket 
>>>> (http://www.mill-max.com/pin_rec_catalog/productInfo.cfm?webpartnumber=4947&start=1&leaddiameterrange=%2E032%2D%2E046&pin_or_rec=rec&PartDescription=Threaded%20Receptacle&taildiameter=&tailtype=&mountingfeature=&mountinghole=&bodylength=&search=&pr=rec&stagecode=)  
>>>> will work. There are also threaded pins (not from Mill-Max).
>>>>
>>>> Best regards,
>>>> Fernando
>>
>>