[Halld-pid] photo of new light guide

[Paul Eugenio]

Hi Tim,

When we get back the vapor polished light guide we will then measure.

Paul

--
Prof. Paul Eugenio
Department of Physics
Florida State University
Tallahassee, FL  32306

eugenio at fsu.edu
(850) 644-2585


On Jul 13, 2011, at 9:14 AM, Tim Whitlatch <whitey at jlab.org> wrote:

> Hi Paul,
> 
> Were any transmission tests done on the unpolished light guide for comparison?
> 
> Tim
> 
> Mark M. Ito wrote:
>> 
>> Looks nice!
>> 
>> On 07/12/2011 03:10 PM, Paul Eugenio wrote:
>>> 
>>> Attached is a photo new bend-cut machined light guide.   
>>> 
>>> We sent an unpolished light guide to East Coast Precision Manufacturing for vapor polishing.  Most of their shop is on vacation this week, but they told me that they would polish it early next week and get it back to us.
>>> 
>>> 
>>> --
>>> Prof. Paul Eugenio
>>> Florida State University
>>> Department of Physics
>>> Tallahassee, Florida,  USA 32306
>>> 
>>> (850) 325-0314
>>> eugenio at fsu.edu
>>> 
>>> 
>>> 
>>>     
>>> 
>>> _______________________________________________
>>> Halld-pid mailing list
>>> Halld-pid at jlab.org
>>> https://mailman.jlab.org/mailman/listinfo/halld-pid
>> 
>> 
>> _______________________________________________
>> Halld-pid mailing list
>> Halld-pid at jlab.org
>> https://mailman.jlab.org/mailman/listinfo/halld-pid
> 
> <whitey.vcf>
> _______________________________________________
> Halld-pid mailing list
> Halld-pid at jlab.org
> https://mailman.jlab.org/mailman/listinfo/halld-pid
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/halld-pid/attachments/20110715/6daffb11/attachment-0002.html>