[Halld-pid] Start Counter Meeting Minutes, May 17, 2012
Mark M. Ito
marki at jlab.org
Fri Jun 1 14:42:09 EDT 2012
Folks,
I realized yesterday that I never wrote up the notes from the meeting
two weeks ago. Here they are, below and at
https://halldweb1.jlab.org/wiki/index.php/GlueX_Start_Counter_Meeting,_May_17,_2012#Minutes
.
-- Mark
_____
GlueX Start Counter Meeting, May 17, 2012
Minutes
Present:
* FIU: Werner Boeglin, Puneet Khetarpal
* JLab: Fernando Barbosa, Chuck Hutton, Mark Ito (chair), Yi Qiang,
Tim Whitlatch, Beni Zihlmann
Simluation
Puneet is going to start background rates studies with the new updated
(30 paddle) geometry.
Mechanical Design
Chuck showed the latest progress on the design. See [22]his slides for
various views of the start counter focusing on the read-out area.
Realistic drawings of the SiPM read-out boards are now included. Some
highlights of the discussion:
* A thermal mat could be used if needed to help cool the boards.
Currently it is not in the plan.
* There is spacer shown between the read-out boards for light
tightening the counter volume.
* Bolt holes holding the SiPM boards (ST1) to the support tube will
serve as positioners.
* A positioning template will be used when scintillators are attached
to the foam to guarantee good alighnment with the SiPM's.
* There will be air gap between the scintillator and the SiPMs.
* There is currently a problem with interference of cable connector
with support tube. A compromise with the target design will have to
be struck.
SiPM Read-Out Boards
Fernando reported that the plan is to send out the design tomorrow. It
should be in fabrication by next week.
Prototype News
Two scintillator samples came in from McNeal. One was badly crazed, but
the other does not look so bad. Timing tests are next (for the good
one).
TDR
Werner continues to working on the TDR
Retrieved from
"https://halldweb1.jlab.org/wiki/index.php/GlueX_Start_Counter_Meeting,_May_17,_2012"
References
22. https://halldweb1.jlab.org/talks/2012-2Q/sc_5_17_12.pptx
--
Mark M. Ito
Jefferson Lab (www.jlab.org)
(757)269-5295
More information about the Halld-pid
mailing list