<div dir="ltr">Dear colleagues,<div><br></div><div>We have produced a new 7mm diamond sample using laser ablation, but this time instead of ablating it down to the final thickness we stopped at 40 microns. We then shipped it off to Applied Diamond for them to etch it, and they took off a final 20 microns for a finished (inner membrane) thickness close to 20 microns. </div><div><br></div><div>When we first looked at it we thought it was cracked, but after discussions with Advanced Diamond engineers we understand that the hairline we saw was just a surface artifact from the apparatus that was used to hold the diamond during the etching. The results look amazing. See the attached photograph. This is in sharp contrast with what we installed in the goniometer back in February, which look black in the inner region due to carbon residue. The bright square in the upper right corner of the images is just a reflection from the camera flash.</div><div><br></div><div>We plan to look at it under a scanning electron microscope to see if there were any micro-pores or cracks created by the etching process, but with an optical microscope it looks as smooth as it did when we finished with the laser. I have written to our collaborator Ken Finkelstein to ask if we might get a few hours for a quick measurement of the rocking curve on this sample. I believe we will see a huge improvement over the un-etched samples JD70-118 and JD70-119.</div><div><br></div><div>-Richard Jones</div></div>