<div dir="ltr">Today would be the regular biweekly meeting of the Photon Beam working group, but I think we can substitute the meeting today with the following summary.<div><ul><li>Mike Dugger continues to work through an issue with slow file transfers between Jefferson Lab and his server at ASU. Last week he and I sat for a work session to study this issue, and we found the issue is larger than just the specific endpoints in question. We found that transfer rates between centrally managed data transfer nodes at ASU and similar endpoints at UConn also showed the same bottleneck, limiting throughput to the range 5-10 MB / s using high-performance tools like globus online and perfsonar. At the same time, I was seeing rates > 500 MB/s from Jefferson Lab to UConn. This seems to be a recent phenomenon because Mike has done transfers in the past using commandline tools and seen much better rates. Mike is reaching out to ASU network experts to try and find out what is going on.</li></ul></div><div><ul><li>Andrew Schick has been occupied on a number of fronts, in preparation for the upcoming CPP run, but he continues to move forward with systematics studies of the analyzing power from his BH analysis. Since the last meeting, I generated new samples of muon pairs to complement the existing e+e- samples, and compare with the UMass generator for both 2H and 208Pb targets. These samples have been reduced (accept/reject, energy, angle cuts) and transferred to Jlab where Andrew has begun to process them through his simulation and analysis pipeline. Problems with the use of MCwrapper for these studies with the UConn generator were explained as due to the use of too old a version of hdgeant4. Andrew has yet to confirm that he is able to run his entire analysis through MCwrapper for both generators, by selecting a newer tagged version of hdgeant4, but I claim that this should be the case.</li></ul></div><div><ul><li>Early on in the SRC run, we have seen contradictory results between the projected photon beam focal spot at the collimator based on extrapolation from the harps and the measured transmission through the collimator. As soon as the run is over, we should have a discussion on what might be the cause of this, and how to improve our ability to determine the photon beam phase space distribution, so that we can reliably predict how changes in the beam tune are related to transmission through the collimator.</li></ul><ul><li>Plans are being finalized for a run in mid-December at the Saskatoon CLS to measure the crystal quality of the 3 new diamond samples obtained in 2020 from Element Six. </li></ul></div><div><br></div><div>-Richard Jones</div><div><br></div></div>