[Halld-tracking-hw] Grounding & Cabling

[Yves Van Haarlem]

Hi Fernando,


Thanks for looking into all this.

Concerning:
>   The alternative, my preference, is to follow Gerard's suggestion of a 
> press-fit receptacle (I have attached a pdf). This can be press-fit or 
> inserted with conductive epoxy into the endplate. The final diameter of this 
> plus the pin on the end of the grounding wire should be ~ 0.1". This part is 
> available from stock, costs $0.625 and there may be a minimum order of 500 
> pieces. The cost should be ~$300.
So in this setup there would be one receptacle/HV-board? Let me see if I 
get it: one glues that -small- recepticle in the enplate. Then a cable 
which has a pin soldered to the end of it is moved through the end-plenum 
and pressed in that recepticle. The cable itself leaves the endplenum and 
is sealed with an o-ring and glue and than connected/soldered to the 
HV-board.

Best regards,
 	Yves