[Halld-tracking-hw] Lamina

[Naomi Jarvis]

Maybe they did, but maybe the drillbits wore down and were replaced at
(irregular) intervals.  As the reaming progressed, starting around the
outermost row and then moving towards the center, we found that the
reaming was at first difficult, and then got progressively easier until it
became suddenly harder again, repeatedly, but with no obvious regular
interval.  Anyway, the reaming is around 2/3 complete now.

Naomi.


On Mon, June 7, 2010 2:10 pm, Tim Whitlatch wrote:
> Great. Thanks!
>
>
> They claimed to have used the same tools on the large plate but
> obviously there was something done differently.
>
> Tim
>
>
> Naomi Jarvis wrote:
>
>> Hi Tim,
>>
>>
>> We are talking about the small practice disk with just 8 holes in ?
>> In which case, yes, the .4375 pin fits through without pressure. It is a
>>  perfect fit, so the pin needs to be lined up exactly, but then it just
>>  slips through easily, no pressure.
>>
>> Naomi.
>>
>>
>>
>> On Mon, June 7, 2010 12:41 pm, Tim Whitlatch wrote:
>>
>>
>>> Hi Curtis,
>>> I just wish to understand clearly.
>>> There was no rework to the holes when the part was received from Meyer
>>>  tool? The .4375 pin fit through without pressure?
>>>
>>> Thanks,
>>>
>>>
>>>
>>> Tim
>>>
>>>
>>>
>>> Curtis A. Meyer wrote:
>>>
>>>
>>>
>>>> Hi Tim,
>>>>
>>>>
>>>>
>>>> the new holes are all correctly sized. Gary was out last week, so
>>>> we had not set up the glue test yet.
>>>>
>>>> curtis On 6/7/10 10:01 AM, Tim Whitlatch wrote:
>>>>
>>>>
>>>>> Hi Naomi,
>>>>>
>>>>>
>>>>>
>>>>> What were the measured diameters of the holes and how did the
>>>>> practice glueing go?
>>>>>
>>>>> Tim
>>>>>
>>>>>
>>>>>
>>>>> Naomi Jarvis wrote:
>>>>>
>>>>>
>>>>>
>>>>>> Great!   Also our Carbon single arrived... (the extra piece for
>>>>>>  glueing practice)... someone had fun with it.
>>>>>>
>>>>>> Naomi.
>>>>>>
>>>>>>
>>>>>>
>>>>>>
>>>>>> Tim Whitlatch wrote:
>>>>>>
>>>>>>
>>>>>>
>>>>>>> Hi Naomi,
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>> Thanks for the offer. I got an email from Lamina today and
>>>>>>> they say they can correct the scratches by changing the
>>>>>>> tooling. Apparently
>>>>>>> there was an aluminum coated guide causing the scratches. They
>>>>>>>  will also redesign the packaging for the future orders.
>>>>>>>
>>>>>>> Tim
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>> Naomi Jarvis wrote:
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>>> Hey Tim, would you like me to talk to the Lamina people for
>>>>>>>>  you? Since we speak the same language :-)    I know it is
>>>>>>>> a JLab contract, but if I can help, let me know. Naomi.
>>>>>>>>
>>>>
>>
>>
>