[Hps-analysis] test pass status for pass1

[Rafayel Paremuzyan]

Hi all,

before starting pass1,
I submitted a new test pass "tpass1c" with 7796 and 8054 (Carbon target)

files are currently being processed, and some of them already have finished

Only for this test pass, DQMs were included, but they will not be 
included during the normal pass, for several reasons
- Nobody actually looked at them at the past, and asking about it in 
several meetings, no one actually requested them to be present
- They actually require more memory usage than the recon itself, i.e. 
rcon is fine with 2.4Gb (Tot Ram from Auger) and 1.4Gb Heap size, while 
for DQM 1.4 Gb Heap is not enough
- DQM takes about 30% of recon time, while other staff (DST and skims) 
are much faster

files are in the following directory
/lustre/expphy/work/hallb/hps/data/physrun2016/tpass1c

Skims and ntuples in terms of file sizes seems fine to me (though users 
need to test them).

I did simple checks of the event timestamps, it seems ok.

So before starting to run the pass1 will be good if users involved in 
the analysis
to check the data.

At least following points, which are specifically were addressed for pass1,
I think is important to check, and mark as "Good"

- Look into skims, make sure it is not too tight,
- Check track parameters for detached vertexes
- Check whether we get the target position close to 0

If nor issue is found, then probably by the mid of next week I can start 
pass1.

Rafo