<div dir="ltr">Hi everyone,<div><br></div><div>I realized as soon as I showed my slide today, that in my effort to clean up some of my plots, I had scaled my reach plot by an additional 10% (and I know from the counts I had seen before that this was not consistent).</div><div><br></div><div>Here's the attached plot of all 1.5mm data from the 2015 run with layer 1 hits for both tracks. I'm curious to see what more we can obtain if I can loosen this layer 1. I'll clean up and post the relevant cut plots and post it to the agenda for today.</div><div><br></div><div>This is assuming that the mass resolution is the same for the larger opening angle (I'll check into this). This also assumes a Zmax of 40 mm (which I also need to check with simulation). At any rate, I would not expect this to dramatically change the results shown here. </div><div><br></div><div>-Holly</div></div>