[Lowq] bos files from pass0_v0

[Hovanes Egiyan]

Hi Stepan,

Lamiaa already cooked all files from 61695 run specifically for EC timing
calibrations a few days ago, and the BOS files are located on the 
permanent eg6 disk at:

/work/clas/claseg6/top_dir/ec_calib/pass0_v1/BOS/

This is the run which we used for TOF and DC calibrations prior to pass0 
v0.

Hovanes.



Stepan Stepanyan wrote:
> Lamiaa,
>
> Thanks for a quick reply.
> So how then we should do calibration that we do not have
> bos files any more. OK, then we need to recook files again.
> In particular for EC time calibration. We need ecpc bank in
> there.
> Can you please cook one full run, say the run you used for
> calibration of TOF counters (by the way where in the wiki
> I can find this information). You can use 64-bit farm to have
> it done quickly.
>
> Thanks, Stepan
>
>
> Lamiaa El Fassi wrote:
>   
>> Hi Stepan,
>>
>> Following Hovanes suggestions, the bos files of the pass0_v0 were
>> copied to the auto-managed work disk only. None of these files was
>> saved on Silo. Only the ANAHIST files and the HBOOK ntuples were saved
>> on the private claseg6 work
>> disk.
>>
>> Best regards,
>>
>> Lamiaa
>>
>> On 7/14/10, Stepan Stepanyan <stepanya at jlab.org> wrote:
>>   
>>     
>>> Is any one knows where bos files from pass0_v0 cooking are.
>>> Do we have them on silo? Is any one keeping track of all these
>>> files?
>>>
>>> Stepan
>>> _______________________________________________
>>> Lowq mailing list
>>> Lowq at jlab.org
>>> https://mailman.jlab.org/mailman/listinfo/lowq
>>>
>>>     
>>>       
>>   
>>     
> _______________________________________________
> Lowq mailing list
> Lowq at jlab.org
> https://mailman.jlab.org/mailman/listinfo/lowq
>