[Moller_simulation] Question about radial acceptance of Moller ring

[yxzhao at jlab.org]

Hi Scott,

The link below you can find the segmentation of all the detectors:
http://129.49.57.128/note/Moller_detector_segmentation.txt

Cameron and Sakib, as well as Ciprian are all using the same numbers.

Thanks

Yuxiang


> Hey Scott,
>
>>From the studies I have last run the radii were (slightly) different for
> the 3 different regions. You can find the values I used here:
> https://github.com/cipriangal/remoll/blob/master/rootScripts/electronRate.C#L86
>
> Cheers,
>
> Ciprian
>
> *************************************************
> Ciprian Gal
> Postdoctoral Researcher
> University of Virginia, Va, USA
> *************************************************
>
> On Tue, Sep 20, 2016 at 12:16 PM, Scott Mundy <scmundy at email.wm.edu>
> wrote:
>
>> Hi this is Scott from William and Mary,
>>
>> I need the radial acceptance of the Moller detector ring (i.e. between
>> which radii it detects hits) in the simulation so that I can place a
>> pion
>> detector in the same range downstream of it for preliminary testing. I
>> was
>> wondering if anyone could point me to a place where this value is
>> written
>> down?
>>
>>
>> Thanks.
>>
>>
>> _______________________________________________
>> Moller_simulation mailing list
>> Moller_simulation at jlab.org
>> https://mailman.jlab.org/mailman/listinfo/moller_simulation
>>
>>
> _______________________________________________
> Moller_simulation mailing list
> Moller_simulation at jlab.org
> https://mailman.jlab.org/mailman/listinfo/moller_simulation
>