<div dir="ltr"><div dir="ltr"><div>Hello,</div><div><br></div><div>I have made a change to the "_merged" geometry in remoll. From commit c1cd234a (from 4 days ago or so) and onward in the develop branch, collimator 4's sculpt has been updated based on the new SBU moller envelope information. Col4 is designed to accept exactly the same flux of mollers as goes through the acceptance defining collimator (col2), and since the prior envelopes used to define that sculpt were too course grained in magnetic fields, the envelope and sculpt did not reflect the reality of the particles traveling in the simulation. Unfortunately, this has been an issue for as long as collimator 4 has been designed off of the old SBU moller envelope (forever?).</div><div><br></div><div>I probably should have made this commit some more dramatic feature inclusion rather than just a commit, since it may change the moller (and other) flux that reaches the detector plane non-trivially, potentially affecting even the radial detector segmentation if the original collimator 4 placement was off by a lot. I did leave the old sculpt values clearly labelled in a comment though, and I have added two new sets of files, "acceptanceDefinition" and "acceptanceDefinition_includeCol4" which are used to define the moller envelope that hits in ring 5 (open, transition, or closed sectors) and the same but including the appropriately sculpted collimator 4 as well (for further cutting out other signals) respectively.</div><div><br></div><div>We may want to do a new comparison of a standard "ideal" all vacuum configuration before and after this new update to see if the moller and ep signals do change significantly.</div><div><br></div><div>Thanks,</div><div>Cameron Clarke</div></div></div>