[Pansophy] Tophat Bellows (TPHTB) Inspection Traveler & Tophat Bellows (TPHTB) Leak Check Traveler

[George DeKerlegand]

Hi Matt,

When you get a chance could you please add the critical dimension nominals and tolerances in step 2? Also, for step 1 what do think of a size limit that's acceptable for dings/dents on bellows?  For LCLS2 Katherine revised the traveler to state 1/8" or smaller in total size deemed acceptable because of so many NCRs created and then later the final disposition was "use as is".  Just a thought.

Thanks,
Aaron
________________________________
From: Megan McDonald <megan at jlab.org>
Sent: Wednesday, April 8, 2020 7:35 AM
To: Matt Marchlik <marchlik at jlab.org>; Katherine Wilson <kwilson at jlab.org>; George DeKerlegand <georged at jlab.org>; Ed Daly <edaly at jlab.org>; Jacob Harris <jharris at jlab.org>; Chris Wilcox <wilcox at jlab.org>
Cc: pansophy <pansophy at jlab.org>
Subject: Tophat Bellows (TPHTB) Inspection Traveler & Tophat Bellows (TPHTB) Leak Check Traveler


Jacob,

Please review and let us know if these need calibration info.



All,

Please let me know if you approve of these travelers. Please make any needed changes to the copies attached.



Thanks,

Megan
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://mailman.jlab.org/pipermail/pansophy/attachments/20200409/10ccba98/attachment.html>